By Daisi Loiseau. driveway. Published at Friday, January 25th, 2019 - 00:19:59 AM.
When you complete the laying of your full blocks you then need to cut in the borders, you can cut bricks using a block splitter. Holding the brick in place over the border, looking from above mark a line onto the full block on each side where it meets the border, draw a line between these 2 points and cut off the surplus using the block splitter, then simply put the cut block in place.
Two Set up your level line. You will need to knock 2 timber or steel pins into the ground, one at the house end of the driveway and the other at the pavement side. Next, attach a tight builder’s nylon line at what will be the finished height of your block paving, this line should be approx 10mm higher than the pavement and 150mm lower than the damp proof course to allow for final compaction of the block paving.
Look for a company that will provide a free, no-obligation quotation for cleaning your property. Ask for client testimonials and go through them to see whether the cleaning job was done with attention to detail. See whether they provide good customer care for their clients.
There are 2 methods you can employ as the bed for block paving, one, you have fully compacted sand making the sub base and the laying coarse much firmer, achieving a much flatter surface. To achieve this you need your sand approx 10 – 15mm higher than the finished screeding height, this surplus sand is screeded off to the correct height and then you lay your block paving.
Any content, trademark’s, or other material that might be found on the Arewacloud website that is not Arewacloud’s property remains the copyright of its respective owner/s. In no way does Arewacloud claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.