By Genivee Marin. driveway. Published at Monday, January 21st, 2019 - 11:26:59 AM.
When you’re spending the money to have your driveway or parking lot professionally paved, you don’t want the asphalt to deteriorate any sooner than necessary. Sealcoat the surface to protect your walking and driving areas from wear and tear.
Two Set up your level line. You will need to knock 2 timber or steel pins into the ground, one at the house end of the driveway and the other at the pavement side. Next, attach a tight builder’s nylon line at what will be the finished height of your block paving, this line should be approx 10mm higher than the pavement and 150mm lower than the damp proof course to allow for final compaction of the block paving.
Sealcoating a pavement area approximately 60 days after the initial asphalt application will protect it from weather and car fluid damage in the years ahead, lengthening the overall life of your paving. Driveway sealer is composed of a coal-tar emulsion, sometimes fortified with rubber or silica sand for increased durability. A paving contractor will apply sealer either by brush or by spraying it over the area; the method may depend upon the size of the area to be sealed, or upon the individual contractor’s preference.
Three Place a geotextile layer (weed control fabric) on top of the subsoil to the total area of your driveway. This eliminates mixing of the sub soil or clay and the hardcore yet still allows water to flow away freely.Hold this in place using a few bricks or blocks and keep it tight whilst adding the hardcore.
Any content, trademark’s, or other material that might be found on the Arewacloud website that is not Arewacloud’s property remains the copyright of its respective owner/s. In no way does Arewacloud claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.