Published at Tuesday, February 05th, 2019 - 19:45:53 PM. driveway. By Daisi Loiseau.
The other way is to have 2/3 compacted sand and a third loose sand which you screed to the desired height, this is easier to screed but can result in soft spots. Establish the finished height of your block paving use a block as a guide and push it down into the sand until it is 5mm higher than the finished height to allow for the final compacting once all the block paving is laid.
When you complete the laying of your full blocks you then need to cut in the borders, you can cut bricks using a block splitter. Holding the brick in place over the border, looking from above mark a line onto the full block on each side where it meets the border, draw a line between these 2 points and cut off the surplus using the block splitter, then simply put the cut block in place.
Any content, trademark’s, or other material that might be found on the Arewacloud website that is not Arewacloud’s property remains the copyright of its respective owner/s. In no way does Arewacloud claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.