Published at Tuesday, February 05th, 2019 - 22:12:00 PM. driveway. By Nannette Courtois.
Two Set up your level line. You will need to knock 2 timber or steel pins into the ground, one at the house end of the driveway and the other at the pavement side. Next, attach a tight builder’s nylon line at what will be the finished height of your block paving, this line should be approx 10mm higher than the pavement and 150mm lower than the damp proof course to allow for final compaction of the block paving.
Hold your level on this line at the house end and either raise or lower it until it is level, if you have a gap under the level and the line on the end facing the pavement, then you have the correct direction of fall in the driveway. When you are satisfied with the height and fall of the line, wrap some tape around the pegs to the underside of your line, this will save having to go through the same process again if the line is moved for any reason.
Any content, trademark’s, or other material that might be found on the Arewacloud website that is not Arewacloud’s property remains the copyright of its respective owner/s. In no way does Arewacloud claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.